HDR Soft Pro - 5.0 - Windows Manual de usuario descargar pdf (Pagina 35)

Photomatix Pro 5.0 User Manual 33

4.2 Batch Processing Single Images

To process a batch of single image les:

1� Open the Batch Tone Mapping of Single Photos window by:

Click the Batch Single Photos button in the Workow Shortcuts panel

Select Batch Single Photos from the Automate menu�

2� To select the source folder that contains the les, click Select Folder, and Navigate to

the folder that contains the les and click OK�

The folder path and the les in the folder will be displayed�

3� Optionally, you may select a subset of the

displayed les to process:

Hold the Control key (Windows) or Command

key (Mac), and click to specify les for

processing�

4� To process the selected les using an existing

preset, select a preset from the Use: Preset

menu�

To Process the selected les using a new

custom setting, select a method from the

Use: Custom Settings for menu, then click

Set..., and then congure the preset as desired�

5� Click the checkboxes for noise reduction and

CA correction, if needed�

6� To select a destination folder, click Created under Source Folder to save the images in the

same folder as the source les�

Click Customized Location to save the images in a

dierent folder�

Click Choose to select the destination folder�

The folder path will be displayed�

7� Select the output le type� When using JPG le output,

select the amount of JPEG compression� 100 gives the least

compressed JPEG le, with most image quality retained�

8� Click Run� The batch processing status displays�

When batch processing is complete, a link to the batch results

will be displayed�

The Batch Single Photos feature is intended

for automating the processing of a lot of

photos. To process a single image le, load the

image le using the information in Section 2.2.

• Specify the total number of frames in each set using the drop-down list�

• Select the specic frames to process from the list� Select more than one le by holding down the Control

key (Windows) or Command key (Mac) and clicking on the desired frames�

To remove the watermark, Photomatix Pro

requires that the image was not retouched after

the watermark was added to it. If the brightness

or contrast of the image was changed, or the

image was double tone mapped, or cropped

or resized, then Photomatix will not be able to

remove the watermark..

Batch Tone Mapping of Single Photos

Note

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Comentarios a estos manuales

Sin comentarios

HDR Soft Pro - 5.0 - Windows Manual de usuario Pagina 35

Comentarios a estos manuales